The installation of Anti Slip Strips For Decking is an important aspect of offering maximum security, most specifically in wet environments, such as pool decks, patios, and exterior sidewalks. Slippery floors can result in slips and falls, and anti-slip strips become a convenient and cost-effective alternative, therefore.
Step-by-step Installation Manual
Check the Decking Surface
Check for decking to mark high-use areas or the most slippery areas. Stairs and ramps fall under high-use areas, and under water and shadowed areas fall under the most slippery areas, respectively. Check and mark down the dimensions of areas in which anti-slip decking strips will be installed in preparation for the calculation of anti-slip strips to be purchased.
Clean the Decking Surface
The anti-slip tapes will require proper adhesion to a dry and clean surface. Start with a broom over the deck to remove leaves, debris, and dirt. Mix mild soap or boat cleaner with water in a bucket. Clean with a cloth or sponge, working over the entire surface and taking care to give specific attention to mold, mildew, and algal regions. Rinse off with new water and allow it to thoroughly dry out. Several hours, depending on the weather, will elapse during drying out.
Mark the Position
Use tape to mark out positioning and spacing for anti-slip decking strips. For a staircase, have a strip at each step, centrally and over a full step width. For level floors, space them out uniformly for even traction. Mark with chalk or a marker where the strips will go in.
Cut Anti-Slip Strips to Length
Cut them with a utility knife or scissors to a preferred length, cutting them in a level and even manner for a completed, expert edge, in the event anti-slip strips become too long.
Install Anti-Slip Strips
Peel off the backing off the adhesive side of the Anti Slip Decking Strips. Position the strip in the decking at the marked position, not overextending it out of shape. Hold down firmly onto the counter, starting at one edge and working towards the other in a move to not have any bubbles form between them. Use a roller, a rolling tool, or a heavy weight to press down with even pressure over the entire strip, holding it firmly onto the decking.
Allow Adhesive to Cure
Once installed, avoid walking over them for a minimum period of 24 hours in an opportunity for adhesive to have a chance to totally seal and form a strong, long-lasting seal.
Planned Maintenance
Check regularly for peeling and wear of anti-slip strips. Clean anti-slip strips regularly to remove any debris and maintain effectiveness. Replace it immediately when a strip is broken or loose for ongoing safe use.
Tips for Maximum Safety: Use High-Quality Strips
Buy anti-slip strips with high-quality, long-lasting, and sunlight-resistant materials that can survive exterior use.
Proper Space: Space them closely enough for constant traction but not closely enough for them.
Use Texture: Opt for tapes with a textured backing for increased traction, particularly in wet environments.
Check the Surface: Once installed, try out the Anti Slip Decking Strips by walking over them to verify that the strips have enough traction.
Comments